Park Brake Installation - Land Pride Accu-Z Razor Z44 Service Manual

Land Pride
SECTION 1: OPERATOR CONTROLS

PARK BRAKE INSTALLATION

1. Install park shaft bushing plate on to one trans-axle.
NOTE: Do not tighten at this time.
2. Place one matching end of park lever shaft weldment,
with bushing, into shaft bushing plate installed in step 1.
photo zsm261
3. Place park shaft bushing plate and bushing on other
end of park lever shaft.
4. Align and install park lever shaft weldment and
bushing plate on the opposite side installed in step 1 to
trans-axle.
5. Tighten all fasteners to standard torque. See chart on
page 63.
photo zsm268
6. Assemble spring link clips and align and install on the
park lever shaft weldment and parking paw.
7. Secure spring link clip assembly with hair cotter pins
and hardware.
8. Repeat steps 6 through 7 for other side.
photo zsm059
9/24/09 Z44 and Z52 Accu-Z Razor (S/N 472620 and above) Riding Mowers 357-044SM 7