Seat Installation - Land Pride Accu-Z Razor Z44 Service Manual

Land Pride
SECTION 2: SEAT AND FRAME

SEAT INSTALLATION

NOTE: Installation of seat, seat support, or arm rests
do not require step by step procedure.
1. Align and install arm rest hardware.
2. Tighten all fasteners to standard torque. See chart on
page 63.
3. Repeat step 1 through 2 for other side.
photo zsm148
4. Remove plastic thread protectors from seat mounting
bolts.
5. Align and install the seat onto seat support.
6. Install seat retaining and alignment nuts, and the
plastic thread protectors, adjusting the seat to desired
position.
7. Tighten all fasteners to standard torque. See chart on
page 63.
photo zsm143
8. Align and install seat support pivot bolt into frame and
seat support.
9. Repeat step 8 for other side.
10. Tighten seat support pivot hardware until snug
against frame.
NOTE: Over-tightening of pivot bolt will not allow the
seat support to move correctly.
photo zsm142
9/24/09 Z44 and Z52 Accu-Z Razor (S/N 472620 and above) Riding Mowers 357-044SM 25