Wiring Harness Removal - Land Pride Accu-Z Razor Z44 Service Manual

Land Pride
SECTION 4: ELECTRICAL SYSTEM

WIRING HARNESS REMOVAL

1. Ensure that control levers are set in the neutral
position and park brake is set for safety.
2. Disconnect battery to prevent accidental shock.
3. Disconnect the wiring harness from control panel. See
control panel removal on page 20.
4. Disconnect the wiring harness from the engine wiring
harness and engine regulator/rectifier.
photo zsm127
5. Disconnect the starter power, and common ground.
6. Disconnect and remove engine oil pressure sensor.
photo zsm132
7. Disconnect the park brake sensor cable and the
operator presence switch.
8. Cut and remove all cable tie retainers to remove
harness.
photo zsm038
38 Z44 and Z52 Accu-Z Razor (S/N 472620 and above) Riding Mowers 357-044SM 9/24/09