Siemens SIMATIC ET 200SP Manual page 12

Properties
The module has the following technical properties:
● Digital output module with 4 outputs (TRIAC)
● Output current 2 A per channel (max. 4 A), total current max. 8 A
(see derating: Technical specifications (Page 44))
● Power rating max. 900 W
● Configurable diagnostics (per channel)
● Configurable substitute values (per channel)
● Suitable for power control of heating systems or infrared sources in drying processes
● Wave packet control to prevent harmonic components
● Startup delay per channel to reduce system loads
● Output filter per channel for soft start or soft stop
● Two operating modes:
– DQ
– PC (PowerControl)
● with one of four control types each:
– Phase control - phase-angle proportional (default)
– Phase control - power-proportional
– Wave packet control - half waves
– Wave packet control - full waves
Table 2- 1 Operating modes of the DQ 4×24..230VAC/2A HF
Property
Number of channels
Control type selection
Configurable temperature
shutdown
Configurable startup delay
Configurable output filter
down/up
Data length Inputs
Outputs
DQ 4x24..230VAC/2A HF digital output module (6ES7132-6FD00-0CU0)
Manual, 02/2018, A5E42404845-AA
DQ
Without value status With value status
(QI)
0 bytes
1 byte
Operating mode
Without value status
(QI) (QI)
4
Yes
Yes
0 ms ... 10 s
0 ms ... 60 s
1 byte 0 bytes
1 byte 8 bytes
Product overview
2.1 Properties
PC (PowerControl)
With value status
(QI)
1 byte
8 bytes
11