Dust Collection - Grizzly G1026 Owner's Manual

Dust Collection

We recommend NOT operating the Model
G1026 without an adequate dust collection
system. This machine creates substantial
amounts of wood dust while operating.
Failure to use a dust collection system can
result in short and long-term respiratory ill-
ness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Model G1026 (Mfd. Since 10/13)
To connect a dust collection hose:
1. Connect the optional Model G4839 (see
Figure 29) to the back of the fence assembly,
then fit a 3" dust hose over the dust hood and
secure in place with a hose clamp.
Figure 29. The Model G4839 dust hood. (Check
with the current Grizzly catalog or www.grizzly.
com to purchase.)
2.
Tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper
performance.
-25-