Grizzly G1026 Owner's Manual page 52

Adjusting the Gibs
Tools Needed
Open-End Wrench 12mm .................................. 1
Hex Wrench 4mm .............................................. 1
To adjust the gibs:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen the jam nuts on the gib adjustment
set screws (see Figure 76).
Gib
Adjustment
Set Screws &
Jam Nuts
Figure 76. Location of set screws and jam nuts
for adjusting gibs.
-50-
3. Evenly adjust the set screws small amounts,
then test the results.
Qty
4. When you are satisfied with the gib adjust-
ment, re-tighten the jam nuts without turning
the set screws.
5.
Re-check the gib adjustment. If necessary,
repeat this procedure.
Model G1026 (Mfd. Since 10/13)