Siemens SINAMICS S120 Function Manual page 24

Supply
Active infeed
Control and status messages
Table 1-2 Active infeed open-loop control
Signal name
ON/OFF1
OFF2
Enable operation
Disable motor operation
Inhibit regenerating
Acknowledge error
Master ctrl by PLC
Table 1-3 Active infeed status message
Signal name
Ready to start
Ready to run
Operation enabled
Fault active
No OFF2 active
Power-up inhibit
Alarm present
Controlled by PLC
Pre-charging compl
Line contactor energized feedback
1-24
Internal Binector Input
control word
STWAE.0 p0840 ON/OFF2
STWAE.1 p0844 1 OFF2 and
p0845 2 OFF2
STWAE.3 p0852 Enable
operation
STWAE.5 p3532 Disable
motor operation
STWAE.6 p3533 Inhibit
regenerating
STWAE.7 p2103 1
Acknowledge or
p2104 2
Acknowledge or
p2105 3
Acknowledge
STWAE.10 p0854 Master ctrl
by PLC
Internal status
word
ZSWAE.0
ZSWAE.1
ZSWAE.2
ZSWAE.3
ZSWAE.4
ZSWAE.6
ZSWAE.7
ZSWAE.9
ZSWAE.11
ZSWAE.12
Display of
internal control
word
r0898.0 A_STW1.0
r0898.1 A_STW1.1
r0898.3 A_STW1.3
r0898.5 A_STW1.5
r0898.6 A_STW1.6
r2138.7 A_STW1.7
r0898.10 A_STW1.10
Parameter
telegram 370
r0899.0 A_ZSW1.0
r0899.1 A_ZSW1.1
r0899.2 A_ZSW1.2
r2139.3 A_ZSW1.3
r0899.4 A_ZSW1.4
r0899.6 A_ZSW1.6
r2139.7 A_ZSW1.7
r0899.9 A_ZSW1.9
r0899.11 A_ZSW1.11
r0899.12 A_ZSW1.12
© Siemens AG, 2005. All rights reserved
SINAMICS S120 Function Manual, 06/05 Edition
PROFIBUS
Telegram 370
PROFIBUS