Siemens SINAMICS S120 Function Manual page 213

Copying the command data set (vector only)
Set parameter p0809 as follows:
1. p0809[0] = number of the command data set to be copied (source)
2. p0809[1] = number of the command data to which the data is to be copied
(target)
3. p0809[2] = 1
Start copying.
Copying is finished when p0809[2] = 0.
Note
In STARTER, you can copy the command data sets (Drive --> Configuration -->
"Command data sets" tab page).
You can select the displayed command data set in the relevant STARTER
screens.
Copying a drive data set
Set parameter p0819 as follows:
1. p0819[0] = Number of the drive data set to be copied (source)
2. p0819[1] = Number of the drive data set to which the data is to be copied
(target)
3. p0819[2] = 1
Start copying.
Copying is finished when p0819[2] = 0.
Note
In STARTER, you can set the drive data sets via the drive configuration.
Function diagram overview (see List Manual)
S 8560
S 8565
S 8570
S 8575
© Siemens AG, 2005. All rights reserved
SINAMICS S120 Function Manual, 06/05 Edition
Command data set (CDS)
Drive data set (DDS)
Encoder data set (EDS)
Motor data set (MDS)
Basic information about the drive system
Data sets
5-213