Denso SE1-BB User Manual page 24

Scanner as Slave
To return a scanner to a slave after it has been used as the master, perform the following procedure.
(1) Use the scanner to scan the "Configure as slave" Bar Code symbol given in Section 11.2 and its procedure in Section
11.1 to set the scanner as a slave.
(2) Set the profile to be used. Use the scanner to scan the "SPP profile" or "HID profile" Bar Code symbol given in Section
11.2 and its procedure in Section 11.1. (When the scanner leaves the factory, the default setting is "SPP profile".)
(3) Wait for the scanner to beep three times after configuration is completed, and press the scanner's trigger switch. Then,
wait approximately two minutes (default) for the master device to connect to this slave.
(4) When connecting to the BA series communications adapter, set the BA series communications adapter as the master and
specify the scanner's Bluetooth
®
Bluetooth address using the configuration software (BASetting).
When connecting to a commercially available Bluetooth
®
Bluetooth device to establish a wireless link. For operations on other Bluetooth
the User's Manual for the respective device.
(5) Wait for the BA series communications adapter (or commercially available Bluetooth
®
Bluetooth wireless link with the scanner as a slave.
(6) Wait for the scanner to beep twice and the indicator LED to turn green (for 0.5 seconds), indicating a successful
connection.
Tip: In addition to "As a master" and "As a slave" parameters, the configuration software (Scan Tune App) provides a choice
of "No slave/master configuration change" that prevents the Bluetooth
change other parameters with the configuration software or batch-process Bar Code symbols (see Chapter 4).
Note:
· If the master device cannot find a scanner available in the vicinity, set a longer inquiry time and let the master device
search it again.
· When the scanner is connected to a commercially available Bluetooth
connection sometimes is not established until the COM port is opened on the device side after identification. Open
the COM port after identification is completed.
· The BA series communications adapter can be connected to the scanner by only the SPP profile.
*
The configuration software (
Switching to Ready state
After the wireless link is established, the scanner switches to the Ready state when the trigger switch is turned off in the
auto-off or momentary switching mode or when the scanner is on standby in the alternate switching mode.
Switching to sleep mode for power saving
When the scanner is in standby, it is switched to the sleep mode to save power.
The transition period from standby to the sleep mode is 30 seconds in the ordinary current mode. In the power saving mode
(default), the scanner immediately switches to sleep mode. Only the configuration software (Scan Tune App) provides a
choice of these two modes.
The scanner in the sleep mode takes more time (approx. 100 ms) to start and complete a scanning operation sequence than on
standby.
®
address. In the case of the BA series communications adapter, set the scanner's
Scan Tune App
) is available as a free download from our website at (http://www.denso-wave.com/).
®
device, search for the scanner from the commercially available
®
wireless link from being broken when you
®
device by the SPP profile, the wireless link
11
®
devices, use the procedures given in
®
equipment) to establish a