JRC JMA-3300 Series Installation Manual page 44

Chapter 3 INSTALLATION OF THE DISPLAY UNIT
3.6 CONNECTING TO THE GPS COMPASS
JLR-20/30
Connect the JRC's GPS receiver
connector.
 Procedure for not using a dedicated cable
When receiving azimuth information data from the GPS compass, connect the necessary
signal lines to the attached NMEA data connector P5 (for J5) using the following
diagram as the reference.
Signal name
Compass data input +
Compass data input -
Compass data output +
Compass data output -
GND
3-14
Connect the CFQ-5469 8-pin connector
labeled with "GYRO COMPASS".
GPS compass connector side
Disconnected
Disconnected
RADAR-4
JLR-10
Sensor throw SD-A
for JLR-20/30
RADAR-3
JLR-10
Sensor throw SD-B
for JLR-20/30
Disconnected
JMA-3300 side
Disconnected
Disconnected
③NSKRX+
④NSKRX-
Disconnected