Factory Settings Of The Inputs And Outputs - Siemens Sinamics CU240D-2 DP Operating Instructions Manual

Installation
4.2 Electrical Installation
The converter reduces high-frequency radiation of the motor holding brake with an internal
interference suppressor. No other RC elements, varistors or freewheeling diodes are
needed.
4.2.15

Factory settings of the inputs and outputs

Factory settings of the inputs and outputs of the control unit CU240D-2
In the factory settings, the fieldbus interface of the inverter is not active.
Figure 4-17 Factory settings of the control units CU240D-2
Changing the function of the inputs and outputs
The function of each color-identified input and output can be set.
To avoid having to change each input individually, you can set multiple inputs and outputs
together using default settings.
The factory setting of the inputs and outputs described above corresponds to the default
setting 7 (switchover between fieldbus and a jog using DI 3).
62
Default settings of inputs and outputs (Page 63)
Converter with the control units CU240D-2
Operating Instructions, 04/2018, FW V4.9 SP10, A5E34262100B AF