7.6.2
Replacing the lines to the solenoid
Refer to:
Figure 7-10: Lines to Solenoid (Zero line, Input line 1, Input line 2)
7.6.2.1 Removing the lines to the solenoid
1.
Carefully disconnect the Zero line from the solenoid.
Warning: The scrubber on the Zero line is filled with a
lithium based compound. Follow local governing
ordinances for disposal.
2.
Remove Input line 1 from the solenoid connector and the other
end from the FilterLine input connector.
3.
Remove Input line 2 from the solenoid connector and the other
end from the sensor connector.
Figure 7-10: Lines to Solenoid (Zero line, Input line 1, Input line 2)
Section 7: Disassembly Guide
7-9