Changing Default Settings - Nellcor NPB-75 Service Manual

4.3.2 Default Settings
The service technician can change two default settings (refer to Table 4-4:

"Changing Default Settings"):

• 3 Min Alert
When the 3 Min Alert is ON, the unit will beep every three minutes
to remind the user that an alarm (or all alarms) are set to OFF.
• BTPS (body temperature, pressure, saturation)
When BTPS is ON, the CO
Table 4-4: Changing Default Settings
Objective
To access the Default
Settings menu (after
accessing the Default
Alarm Limits menu)
To change the setting
To access BTPS
parameter (and save
the changed setting for
3 Min Alert)
To reset and return to
measuring mode
(automatically erasing
event messages
memory)
To exit service mode
and save event
message
value is corrected for this factor.
2
Action Response
long press
short press
short press
long press
Turn off the
monitor.
Section 4: Service Mode
4-9