Aiwa NSX-D7 Operating Instructions Manual page 6

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two size AA (R6) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
>/+> PRESET
W+b PRESET on the remote control
The function is the same as that of +* on the main unit.
m
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
To turn the power on
Press one of the function buttons (TAPE, TUNER, VIDEO/AUX,
CD, MD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
POWER is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
To turn the power off
Press POWER.
Illumination guides
Whenever one of the function buttons is pressed, the buttons for
that operation light up or flash.
Flash windows
The windows of the CD compartment and the cassette decks
light up or flash while the unit is being powered on.
To turn off the light of the CD window, press while pressing
CD. To turn back on, repeat the above.
To turn off the light of the cassette decks, press while pressing
TAPE. To turn back on, repeat the above.
. Do not perform this operation during recording.
To change the brightness level of the display
1
2
3
Press ECO so that "ECO MODE is displayed.
Within 4 seconds, turn MULTI JOG to display "DIM MODE",
and then press ENTER within 4 seconds.
Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
The mode will be automatically set after 4 seconds. It will
also be set if ENTER is pressed within 4 seconds after step
3.
DIM-OFF +DIMMER 14-+ DIMMER2++ DIMMER3
DIM-OFF: The normal display.
DIMMER 1: The illumination of the display is dimmer than usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3: The illumination of the display is dimmer than
DIMMER 2. The spectrum analyzer, the window of
the CD compartment and the button lamps light
off
m
If the timer recording (page 26) is done with the economizing
mode (page 6) set to "ON" and the power turns off, the dimmer
mode will be set to "DIMMER 3 the next time the power is turned
on.
5
ENGLISH