Interrupt Delay; Class Change - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
EN54-2 : 7.11.d.
Configured delays MUST
be set to interruptable
(Y) to remain EN54
compliant.
CBE Rule:01
>:Change :Accept
CBE Rule:01
>:Change
6
CBE Rule:01
> : Change : Accept
CBE Rule:01
> : Change
6

5.7.5 Interrupt Delay

The Interrupt Delay option has two settings, Yes (Y) or
No (N). This option is only available with the Fire rule.
Caution: Selecting
To change the Interrupt setting from the CBE Output
Rules menu:
1 Press the '
select the Interrupt option.
CBE Rule:01
4:Silence
5
2 Press the '
Refer to Section 5.7, Control-by-Event Output
Rules for further information.
Interrupt = [N]
< : Cancel
:Accept
3 Confirm the selection by pressing the '
5
cancel the selection, press '
menu below is re-displayed.
CBE Rule:01
4:Silence

5.7.6 Class Change

This control parameter has two options, Yes (Y) and No
(N). These indicate whether or not the selected CBE
Rule's assigned outputs activate when Digital Input 1 is
configured as Class Change and then operated. To
configure Class Change, from the CBE Output Rules menu:
1 Press the '
select the Class Change option.
CBE Rule:01
6
2 Press the '
Refer to Section 5.7, Control-by-Event Output
Rules for further information.
Class Change = [N]
< : Cancel
Class Change = [Y]
: Accept
3 Confirm the selection by pressing the '
5
cancel the selection, press '
menu below is re-displayed.
CBE Rule:01
87
'No' contravenes
requirements of EN54.
' button using the numeric keypad to
5
1:Type 2:Filter
5:Interrupt
' button to select the required setting.
6
Interrupt = [Y]
< : Cancel
4
1:Type 2:Filter
5:Interrupt
' button using the numeric keypad to
6
6:Class Change 7:Two Zone
9:Zones
' button to select the required setting.
6
< : Cancel
4
6:Class Change 7:Two Zone
9:Zones
997-263-000-11, Issue 11
the
3:Evac
: More
' button. To
5
'. In either case the
3:Evac
: More
: More
' button. To
5
'. In either case the
: More
January 2010