Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual page 111

ID50 Series Panel - Installation, Commissioning & Configuration Manual
3
1
A2.3 Changing VIEW
The following procedure describes how to configure the
sensitivity levels for alarm (alarm and pre-alarm), day
(alarm and pre-alarm) and sensor grouping for a VIEW
sensor.
1 Follow the procedure in Section A2.2, Learning
Individual VIEW
configuration menu. The LCD shows current settings
and editable parameters. Using the numeric keypad,
press ' ' to select the 'Sensitivity' option.
3
Note: Use the '
2
next address respectively.
[Sensor nn - AVS] 1 : Zone (nn)
3 : Sensitivity 4 : [
2 The LCD then displays the VIEW
menu. The sensitivity is displayed as two values in
brackets. The first signifies the alarm level (default
L5), and the second the pre-alarm level (default 5).
[Sensor nn - AVS]
1 : Alarm(L5,5) 2 : Day(L5,5)
3 To change the 'Alarm'; 'Day' or 'AVSGroup' options,
using the numeric keypad press '
respectively. If '
prompts for a new 'alarm' level as follows:
[Sensor nn - AVS]
Enter new alarm level : ____
4 Using the numeric keypad enter the required 'alarm'
value 1 to 9, and press '
automatically prompts for the 'pre-alarm' value as
follows:
[Sensor nn - AVS]
Enter new prealarm level : ____
5 Enter the required 'prealarm' value 0 to 9, and press
' ' to confirm. The LCD then automatically returns
5
to the VIEW sensor Sensitivity menu.
TM
Day Mode Levels
The 'Day' option alarm levels are changed in the same
manner as the 'Alarm' option.
Using the numeric keypad, press '
option, then follow the procedure above.
A2 - 5
Sensor Sensitivity
TM
Sensors to access the sensor
TM
/ ' buttons to select the previous/
8
2 : Type
Blank/Existing Text
sensor Sensitivity
TM
Sensitivity
3 : AVSGroup(01)
', '
1
' (Alarm) is pressed the LCD
1
Sensitivity
< : Cancel
' to confirm. The LCD then
5
Sensitivity
< : Cancel
' to access the Day
2
997-263-000-11, Issue 11
January 2010
TM
]
' or ' '
2 3