Access Options - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
5
or
2 1
8
1
6
5

5.9 Access Options

The Access options menu allows the configuration of
the following access passcodes:
a. Up to ten (10) User passcodes.
b. One Commissioning engineer passcode.
The Access option is available from the Commissioning
menu. To configure access passcodes:
1 At the Commissioning menu, using the numeric
keypad press the '
options menu.
[S1 COMM] 1 : Setup
3 : CBE Rules 4 : Zones 5 : Access
2 Use the numeric keypad to select the appropriate
option:
a. Press the ' ' button to select the User option.
1
b. Press the ' ' button to select the Engineer option.
2
[S1 Access] 1 : User
3 Selecting the User option ('
keypad) displays the following menu:
[S1 Access] Passcode 0 = nnnn
>:Change 1:Delete
i Use the ' /
2 8
number (range 0 to 9).
[S1 Access] Passcode 3 = nnnn
>:Change 1:Delete
ii Press ' ' on the numeric keypad to delete the
1
currently displayed access code and disable that user.
[S1 Access] Passcode 3 = ________
>:Change 1:Delete
iii Press the ' ' to display the change menu, see below.
6
4 The change menu prompts for entry of a new access
code:
[Setup] Passcode 0
Enter new value ____
Note: If the Engineer option is selected the access code
number is replaced by (ENG).
5 Using the numeric keypad, enter a new four (4) digit
passcode and press '
'User' passcode the display automatically returns to
the User passcode selection menu. The 'Engineer'
passcode returns to the Access menu.
93
' button to display the Access
5
2 : Circuit
: More
2 : Engineer
' on the numeric
1
: More <:Cancel
' buttons to select a user access code
: More <:Cancel
: More <:Cancel
= nnnn
: Confirm <:Cancel
' to confirm. After editing a
5
997-263-000-11, Issue 11
January 2010