Table of Contents
Advertisement
About This Manual
This section describes important information about the design of this document.
Purpose
The purpose of the Juniper Networks G10 CMTS Getting Started manual is to provide
experienced personnel the procedures required to properly install and configure the G10
Cable Modem Termination System (CMTS).
If you do not have experience with the installation and configuration of CMTS equipment in
cable headends, or if you need more details regarding the installation, configuration, or
upgrading of the G10 CMTS, then it is recommended that you follow the procedures
provided in the companion manual Juniper Networks G10 CMTS Installation and Configuration
for more detailed information.
Additional instructions and details regarding the subsequent and on-going operation of the
CMTS can be found in the documents listed in "G10 CMTS Document Set" on page xi.
Organization
Juniper Networks G10 CMTS Getting Started is organized as follows:
Chapter 1, "G10 CMTS Hardware Overview" – Provides a hardware overview of the G10
CMTS.
Chapter 2, "G10 CMTS Installation" – Provides the procedures that must be followed to
install the G10 CMTS in the headend.
Chapter 3, "G10 CMTS Configuration" – Describes the configuration procedure for the
G10 CMTS.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
About This Manual
ix
Advertisement
Table of Contents
