Table of Contents
Advertisement
Installing a Rear-Loaded Module
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Figure 10: Rear-Loaded Module Installation
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
20
Juniper Networks G10 CMTS Getting Started
2.
Unlock the ejectors of the module to be installed so that each ejector rests at
approximately 45° away from its locked position.
Unlike front-loading modules, the ejectors on rear-loading
modules lock in the horizontal position (90° from the
faceplate) when the module is properly installed into its
card slot.
3.
Align the printed circuit board of the module with the card guides and slowly slide the
module into the slot until it comes to a stop with the inside tabs (tabs closest to
midplane) of the upper and lower ejectors resting directly under and over, respectively,
the module ejector rail (refer to Figure 10 on page 20).
4.
Simultaneously close the ejectors toward the module faceplate to the horizontal position
until each ejector release clicks into position.
5.
Tighten the two retainer screws by applying 3 in lb of torque to each screw.
0
U S
1
U S
2
U S
1
3
U S
0
E t h
1
E t h
2
0
D S
1
D S
2
D S
3
D S
2
Advertisement
Table of Contents
