Table of Contents
Advertisement
7.
8.
Configuring Fast Ethernet Interfaces
The procedure in this section enables the two Fast Ethernet interfaces on the DOCSIS
Module/HFC Connector Module pair in slot 1:
1.
2.
3.
4.
5.
6.
Configuring Gigabit Ethernet Interfaces
To configure and enable a Gigabit Ethernet interface, you must have a group-privilege of ip-rw
and you must enter the interface gigaEthernet sub-mode.
The procedure in this section enables the two Gigabit Ethernet interfaces on the NIC Module
slot 5:
1.
2.
At this point, if you desire to view the upstream channel 0 parameters and status, enter
the following command:
G10$root(config-if-c1/0)# cable upstream 0 show↵
Enable upstream channel 0:
G10$root(config-if-c1/0)# no cable upstream 0 shutdown↵
Exit back to the configure terminal mode:
G10$root(config-if-c1/0)# exit↵
Enter the interface fastEthernet sub-mode, specifying slot 1 and interface 0 for Fast
Ethernet port 0:
G10$root(config)# interface fastEthernet 1/0↵
Enable Fast Ethernet port 0:
G10$root(config-if-f1/0)# no shutdown↵
Exit back to the configure terminal mode:
G10$root(config-if-f1/0)# exit↵
Enter the interface fastEthernet sub-mode, specifying slot 1 and interface 1 for Fast
Ethernet port 1:
G10$root(config)# interface fastEthernet 1/1↵
Enable Fast Ethernet port 1:
G10$root(config-if-f1/1)# no shutdown↵
Exit back to the configure terminal mode:
G10$root(config-if-f1/0)# exit↵
Enter the interface gigaEthernet sub-mode, specifying slot 5 and interface 0 for Gigabit
Ethernet port 0:
G10$root(config)# interface gigaEthernet 5/0↵
Configuring the G10 CMTS
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
G10 CMTS Configuration
45
Advertisement
Table of Contents
