Juniper G10 CMTS Getting Started page 48

Powering On the G10 CMTS
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
36 Juniper Networks G10 CMTS Getting Started
6. Immediately after the G10 CMTS is powered on, check that the Test LED on every
DOCSIS Module faceplate is green and blinking (refer to Figure 19 on page 37). This
indicates that the module's self test is running. Continue to monitor each module's Test
LED until it stops blinking, at which point a green illuminated LED indicates the
successful completion of that module's self test. LEDs 1 through 6 should be green,
indicating all software has been successfully loaded and initialized.
7. Immediately after the G10 CMTS is powered on, check that the Power LED on the
Chassis Control Module faceplate is green (refer to Figure 19 on page 37).
8. Immediately after the G10 CMTS is powered on, wait for the OK LED on the NIC Module
faceplate to illuminate green, which indicates the module initialization has been
successfully completed (refer to Figure 20 on page 38).
9. The OPERATIONAL LED at the top of the NIC Access Module rear panel should be
illuminated green after confirming the OK LED on its corresponding NIC Module is in the
correct state as described in the previous step (refer to Figure 20 on page 38).