Table of Contents
Advertisement
Figure 8: Power Supply Installation
Installing a Front-Loaded Module
This section describes the procedure for installing a DOCSIS Module, a Chassis Control
Module, and a NIC Module. Refer to Figure 7 on page 16 and Figure 5 on page 6 for views of
the front, rear, and top of the chassis midplane.
DOCSIS Modules are installed in front card cage slots 1 through 4 (for Domain A) and
slots 10 through 13 (for Domain B).
Do not install DOCSIS Modules that support the DOCSIS
standard and DOCSIS Modules that support the
EuroDOCSIS standard within the same G10 CMTS chassis.
DOCSIS Modules that support EuroDOCSIS are labeled as
such on the front panel of the module.
Chassis Control Modules are installed in front card cage slot 6 (for Domain A) and slot 7
(for Domain B).
NIC Modules are installed in front card cage slot 5 (for Domain A) and slot 9 (for Domain
B). NIC Modules are shipped from the factory with two Multi-Mode GBIC modules
installed. If you are using a different GBIC module interface, you will need to replace the
Multi-Mode GBIC modules that are shipped with the NIC Module. GBIC module removal
and installation is performed while the NIC Module is installed in the chassis.
r
w e
P o
l t
F a u
1
2
Installing a Front-Loaded Module
G10 CMTS Installation
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
17
Advertisement
Table of Contents
