Table of Contents
Advertisement
Chapter 1
G10 CMTS Hardware Overview
This chapter provides an overview of the modules and various hardware components of the
G10 Cable Modem Termination System (CMTS), and where they reside within the chassis.
This overview presents material that is specific to the installation and configuration of the
G10 CMTS. For more details and specifications regarding these assemblies, refer to the
Juniper Networks G10 CMTS Functional Description.
Figure 1 on page 2 illustrates a front view of a fully-configured chassis. Figure 2 on page 3
illustrates a front view of a partially-configured chassis in which DOCSIS Modules, a Chassis
Control Module (CCM), a Network Interface Card (NIC) Module, power supplies, air
management modules, and power supply filler panels have been removed. Figure 3 on
page 4 illustrates a rear view of a fully-configured chassis. Figure 4 on page 5 illustrates the
rear view of the partially-configured chassis in which HFC Connector Modules, a CCM Access
Module, a NIC Access Module, and air management panels have been removed. Figure 5 on
page 6 provides a top view of the chassis midplane showing the slot enumeration and
location of each module.
All of the features of the chassis that are cited in these figures will be referenced in one or
more procedures described in this document.
G10 CMTS Hardware Overview
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
1
Advertisement
Table of Contents
