Table of Contents
Advertisement
Powering On and Configuring the PC
1.
2.
3.
Logging In and Out of the G10 CMTS
1.
2.
3.
Power on the personal computer (PC) attached to the serial port of the Chassis Control
Module.
Launch your asynchronous terminal emulation application (such as Microsoft Windows
Hyperterminal), and establish a direct connection. Configure the port settings as follows:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
When a successful connection is made between the PC and the G10 CMTS, the terminal
emulation screen on your PC will display a banner and prompt you for a login
username:
Copyright (c) 2000-2002 Juniper Networks, Inc.
sw_rev_num
G10 CMTS Release
Login:
where:
sw_rev_num represents the software revision number
Type root at the login prompt and press ENTER:
Login: root ↵
You will then be prompted for a password. Type changeme as the password and press
ENTER:
Password: changeme ↵
You will see the following Command Line Interface (CLI) system prompt:
G10$root#
If desired, you can logout of the system as follows:
G10$root# logout↵
Powering On and Configuring the PC
G10 CMTS Configuration
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
39
Advertisement
Table of Contents
