WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-13
2) TESTING AUTOMATIC STOP ACTION
a) First, connect battery (+) terminal to terminal "B" and its (–)
terminal to black lead wire (2), and let the motor (1) turn.
b) Then disconnect terminal "B" from battery and let the motor
(1) stop.
c) Next connect terminal "A" to battery (+) terminal. Observe the
wiper motor (1) turns once again, then stops at a given posi-
tion.
d) Repeat these steps several times, and inspect if the motor (1)
stops at the given position every time.
REAR WIPER ARM
REMOVAL
1) Remove rear wiper arm mounting nut.
2) Remove wiper arm and blade assembly by using special tool as
shown.
Special Tool
(A): 09913-60910
INSTALLATION
1) Install rear wiper arm and blade assembly.
2) The wiper blade (1) set down alining blade with the bottom heat
wire (2).
3) Install wiper arm mounting nut (3).
Tightening Torque
.
(a): 8 N
m (0.8 kg-m, 5.9 lb-ft)