Overall Flow Of Screen - Mitsubishi LE-40MTB-E Instruction Manual

3.2 Overall flow of screen

The figure below shows the overall configuration of screen displays.
The data can be read in turn using the
Four major screens are available. Those are the initial setting screen, operator screen of usual operation,
engineer screen for system setting and memory cassette data transfer screen. This section shows the over-
all flow of the operator screen that is used in usual operation and the engineer screen. For other screens,
refer to the relevant sections.
Operator screens
(usual operation)
AUTO
switch
Initial Dia. setting (*1)
MANUAL
switch
Length monitor (*1)
SWITCH
Unit
Control
reels
Number of
reels
Taper
Actuator
Stall
AI2
AI3
MC5
MC6
*1 It is displayed exclusively when the LE-40MD is connected.
*2 It is displayed and can be set when the LE-40MD is not connected or when the LE-40MD is connected
but not turn on.
However, the set value is invalid. (The set value is valid when the LE-40MD is connected.)
Tension set
screen
Stall setting
(New reel setting)
(Taper setting)
Manual set
screen
Tension monitor 1
Tension monitor 2
(Diameter monito)
Speed monitor (*1)
Password
screen
Including all functions except the password setting on the initial setting screen .
Settings made during the initial setting can be changed as necessary .
Engineer screens (system parameters and operation parameters )
TENSION
START
AND
Filter
STOP
(Display)
Filter
Start‚s
(Output)
Stop‚s
ZT
Stop‚f
Zero
adjustment Stop‚a
Span
Out‚f
adjustment
Full scale
and keys.
Instal mode only
REEL REEL
CHANGE
Mech.loss
Diameter
Preset T
Cut torque
7
Initial setting
screens
Power on
for the
first time
Initial setting
Pass word
Full scale setting
Zero/Span adjustment
Confirm setting
OTHERS GAIN
Contact Gain
monitor adjustment
Voltage
monitor
MD monitor *1
Revolution *1
signal
Set
inhibition
Initialize
memory
40 MD *2
Diameter
calculation
unit set