Overall Flow Of Screen - Mitsubishi LE-40MTA-E Instruction Manual

3.2 Overall flow of screen

The figure below shows the overall configuration of screen displays.
The data can be read in turn using the
Four major screens are available. Those are the initial setting screen, operator screen of usual operation,
engineer screen for system setting and memory cassette data transfer screen. This section shows the over-
all flow of the operator screen that is used in usual operation and the engineer screen. For other screens,
refer to the relevant sections.
AUTO
switch
MANUAL
switch
Switch
Unit
Control
reels
Number of
reels
Taper
Actuator
Stall
AI2
AI3
MC5
MC6
and
Operator screens
(usual operation)
Tension set
screen
Stall setting
(New reel setting)
Taper setting
Manual set
screen
Tension monitor 1
Tension monitor 2
Diameter monito
Password
screen
Including all functions except the password setting on the initial setting screen.
Settings made during the initial setting can be changed as necessary.
Engineer screens (system parameters and operation parameters )
Tension Start
and stop
Filter
(Display)
Start T
Filter
Stop T
(Output)
Stop G
ZT
Stop B
Zero
Out G
adjustment
Span
adjustment
Full scale
keys.
Instal mode only
Reel change Reel
Preset T Mech.loss
Cut torque Diameter
7
Initial setting
screens
Power on
for the
first time
Initial setting
Pass word
Full scale setting
Zero/Span adjustment
Confirm setting
Others Gain
Contact Gain
monitor adjustment
Voltage
monitor
Set
inhibition
Initialize
memory