Pc Configuration; Tcp/Ip Networking Setup - Advantek Networks AWR-11N-RT User Manual

All manuals and user guides at all-guides.com
hardware damage, use other power adapter may cause hardware damage her power
adapter may cause hardware damage adapter may cause hardware damage may cause
hardware damage hardware damage.

2. PC Configuration

To communicate and configure 802.11n AP router, the PC on your LAN must install TCP/IP
protocol. Make sure the TCP/IP protocol of the PC is configured for Obtain IP address from
DHCP and is connected to LAN (Ethernet) port of the AP router. In doing so, the PC obtains
an IP address of 192.168.1.1 from 802.11n AP router.
The 802.11n AP router assumes an IP address of 192.168.1.1 without network connectivity.
This IP address is used for communicating with the 802.11n AP router via the web UI or
Telnet, with the PC connected to the LAN port.
The 802.11n AP router assumes a DHCP IP address on the WAN side if connected to the
network. In this case user can communicate with the same IP address 192.168.1.1 with PC
connected to the LAN port. PC in the network can communicate with the DHCP IP address
allocated to 802.11n router.

2.1 TCP/IP Networking Setup

Checking TCP/IP Settings for Windows 9x/Me
a) Select "Start Control Panel Network", the window below will appear,
9