Table of Contents
Advertisement
All manuals and user guides at all-guides.com
In PBC Method
(PBC-Push Button Communication), while the AP router acts as Registrar or
Enrollee, and click "Start WPS Config" button, the WPS (Wi-Fi Protected Setup) will establish
the connection automatically.
[WPS Config]
WPS Config Method:
Define the configure method by PIN number or PCB.
Add Enroll PIN Code:
While you define the AP acts as a Registrar and assign the configure
method is by PIN, you can add others enrollees PIN code.
3.4 Information
The Information contains the following sections:
System Information
Routing Table
Pack Statistics
System Log
3.4.1 System Information
This page displays the current information for the device. It will display the LAN, WAN, and
system firmware information. This page will display different information, according to WAN
setting (Static IP, DHCP, or PPPoE)
If your WAN connection is set up for Dynamic IP address, there will be a
Release IP
button
and
Renew IP
button. Use
Release IP
to disconnect from your ISP and use
Renew IP
to
connect to your ISP.
If your WAN connection is set up for PPPoE, there will be
Connect
button and
Disconnect
button. Use
Disconnect
to drop the PPPoE connection and use
Connect
to establish the
PPPoE Connection.
Click System Information on Information, below screen will prompt for System Information.
59
Advertisement
Table of Contents
