Lan - Advantek Networks AWR-11N-RT User Manual

All manuals and user guides at all-guides.com
Default Gateway: Check with your ISP provider.
WAN L2TP Interface Type:
L2TP WAN IP address: Check with your ISP provider.
Subnet Mask: Check with your ISP provider.
L2TP Account: Check with your ISP provider.
L2TP Password: Check with your ISP provider.
L2TP Gateway Mode: Check with your ISP provider.
L2TP Server IP Address:
MTU (576-1500): Specify the network MTU rate. Default: 1400
L2TP Max Idle Time: Default is 300 seconds.
L2TP Connection Mode:
Default is Keep Alive.
Set DNS Server: Default setting is Automatically. If you choose Manually, specify the IP
address of the primary DNS server and the secondary DNS server.

3.2.2 LAN

When the module operates in the Gateway mode, it supports the NAT (NAPT)
feature. It means the WAN and LAN interfaces are located in different network segments and
therefore the date traffic needs to be routed between the two interfaces.
To communicate with 802.11n router properly, must assign an IP address to the LAN
port of the user's PC. There are two ways to assign a proper IP address to the user PC's LAN
port:
Manual configuration of the user PC: This required if the user configures
the 802.11n router WAN port with a static IP address.
Dynamic IP assignment with DHCP: 802.11n router can act as a DHCP
server which dynamically assigns an IP address to user's PC located in the
LAN-side network.
Click LAN on Network Settings, below screen will prompt for LAN setting.
Check with your ISP provider.
Check with your ISP provider.
There are 3 options Keep Alive, Dial on demand, Manual on.
30