Pt Command Transferred From Analog Voltage; Description; System Configuration - Delta ASDA Series Application Notes

ASDA Series Application Note

4.3 PT Command Transferred from Analog Voltage

4.3.1 Description

In ASDA-A2 control mode, analog signal can directly control speed and torque. For example, if
wish to use analog signal (+10V/-10V) to find motor position, the positioning function that
transfers analog speed to pulse can be used. The required parameters and setting methods are
described in this section.

4.3.2 System Configuration

The range of input voltage is from +10V to -10V. The input voltage value corresponds to the
motor position.
March, 2015
Figure 4.3.1 Analog input corresponds to motor position
Chapter 4 Application Techniques
4-17