Work Flow - Omron NJ Series Network Connection Manual

7.2. Work Flow

The following is the procedure for making connection settings for remote I/O communications
of DeviceNet.
7.3 Setting Up the Inverter
↓
7.3.1 Hardware Setting
↓
7.3.2 Parameter setting
↓
7.4 Setting Up the Controller
↓
7.4.1 Hardware Settings for the
DeviceNet Unit
↓
7.4.2 Starting the Sysmac Studio and
Importing the Project File
↓
7.4.3 Going Online and Transferring
the Project Data
↓
7.5 Setting Up the Network
↓
7.5.1 Starting the CX-Integrator and
Opening the Project File
↓
7.5.2 Going Online and Transferring a
Scan List
↓
7.6 Connection Status Check
↓
7.6.1 Checking the Connection Status
↓
7.6.2 Checking Data that are Sent and
Received
Precautions for Correct Use
Obtain the latest "Sysmac Studio project file" and "CX-Integrator project file" from OMRON in
advance.
(To obtain the files, contact your OMRON representative.)
7. Connection Procedure
Set up the Inverter (3G3MX2 series).
Mount the DeviceNet Communications Unit on the
Inverter.
Set the parameter of the Inverter.
Set up the Controller.
Set the hardware switches on the DeviceNet Unit
and connect to the Controller.
Start the Sysmac Studio, and import the Sysmac
Studio project file.
Go online with the Sysmac Studio and transfer the
project data to the Controller.
Set up remote I/O communications of DeviceNet.
Start the CX-Integrator and open the CX-Integrator
project file.
Go online with the Controller, and transfer the
setting (scan list) of the set device to the DeviceNet
Unit via the Controller.
Check the status of the DeviceNet network
connection.
Confirm that the DeviceNet communication is
correctly performed.
Confirm that the correct data are sent and received.
12