Omron NJ Series Network Connection Manual page 46

10. Appendix 2 Setting Procedure without the Configuration Files
10.4 Setting up the Network by
CX-Integrator
↓
10.4.1 Start the CX-Integrator and
Creating Network Configuration
↓
10.4.2 Setting the Device
↓
10.4.3 Going Online and Transferring
the Scan List
↓
7.6 Connection Status Check
↓
7.6.1 Checking the Connection Status
↓
7.6.2 Checking Data that are Sent and
Received
Set up remote I/O communications of DeviceNet.
Start the CX-Integrator and configure the network
and device offline.
Set the device and register it in the DeviceNet Unit
(create a scan list).
Go online with the Controller, and transfer the
setting (scan list) of the set device to the DeviceNet
Unit via the Controller.
Check the status of the DeviceNet network
connection.
Confirm that the DeviceNet communication is
correctly performed.
Confirm that the correct data are sent and received.
43