Basic Controls - Grizzly G0757 Owner's Manual

Refer to Figures 1–3 and the following descrip-
tions to develop an understanding of the basic
controls used to operate the milling machine. This
knowledge will be necessary to safely complete
the Test Run later in this manual.
Additional details for certain controls are also
located in the Operations section.
Master Power Switch
Master
Power Switch
Figure 1. Location of master power switch.
Master Power Switch: Enables power to flow to
the machine when the "l" is visible at the top of
the switch.
Master Control Panel
A
B
C
D
Figure 2. Master control panel.
Model G0757 (Mfg. Since 6/13)

Basic Controls

A. Power Lamp Button: When pressed, illu-
B. Forward Button (Vertical
Spindle rotation direction can ONLY be
changed when the spindle is completely
stopped.
C. Reverse Button (Vertical Spindle
D. STOP Button (Vertical Spindle ): Stops
E. Emergency STOP Button: Disables power
F.
G. Reverse Button (Horizontal Spindle
I
H. Forward Button (Horizontal Spindle
H
G
I.
F
E
minates and enables power to both control
panels. Both Emergency STOP buttons must
be reset first.
vertical spindle forward rotation (clockwise
looking down on the headstock).
vertical spindle reverse rotation (counter-
clockwise looking down on the headstock).
vertical spindle rotation.
to both control panels and stops all machine
functions. To reset, twist the button clockwise
until it pops out.
STOP Button (Horizontal Spindle
horizontal spindle rotation.
Starts horizontal spindle reverse rotation
(clockwise as viewed from the front of the
machine).
Starts horizontal spindle forward rotation
(counterclockwise as viewed from the front of
the machine).
Coolant Pump Switch: Starts/stops the
coolant pump and the flow of coolant.
Spindle): Starts
): Starts
): Stops
):
):
-5-