Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0678 (Mfd. Since 06/15)
manual
BEFORE
Basic Controls
Refer to Figure 11 and the following descriptions
to understand the basic controls of your mill.
B
A
F
Figure 11. Control panel.
A. Power Lamp: Lights when there is power to
the machine.
B. Direction Switch: Controls the direction of
spindle rotation.
C. Digital Speed Readout: Displays the spindle
speed in revolutions per minute (RPM).
D. Speed Dial: Controls the spindle speed.
E. E-Stop Button: Turns the spindle OFF. You
must twist this button clockwise
pops out before restarting the spindle with the
ON button.
Note: Pressing this button DOES NOT dis-
connect the mill from power.
F.
ON Button: Turns the spindle ON when
there is power to the machine and the stop
button is not pushed in.
C
E
D
so that it
-17-
Advertisement
Table of Contents
