Inventory - Grizzly G0757 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Small Item Inventory (see Figure 6):
A. Open-End Wrenches 17/19, 22/24mm ..1 Ea
B. Bottle for Oil ............................................... 1
C. Toolbox ....................................................... 1
D. Spindle Sleeve R-8–MT#3 ......................... 1
E. End Mill Arbor R-8–1" ................................. 1
F. Drill Chuck Arbor R-8–B16 ......................... 1
G. Spindle Sleeve MT#3–MT#2 ...................... 1
H. Drill Chuck B16, 1–13mm w/Chuck Key ..... 1
I. T-Bolts M14-2 x 60 ..................................... 2
— Flat Washers 14mm ................................ 2
— Hex Nuts M14-2 ...................................... 2
J. Hex Wrenches 8, 6, 5, 4, 3mm .............1 Ea
K. Horizontal Arbor 1
L. Horizontal Arbor 1" Dia. w/Spacers ............ 1
M. Vertical Spindle Drawbar
N. Horizontal Spindle Drawbar
⁄ –20 x 13 ⁄ " ............................................. 1
7 3
16 4
-16-
Qty
⁄ " Dia. w/Spacers ......... 1
1
4
⁄ –20 x 20" ....... 1
7
16
B
A D
J
I
K
L
Figure 6. Small item inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0757 (Mfg. Since 6/13)
C
E
F
G
H
M
N