Ball Oilers - Grizzly G0757 Owner's Manual

Ball Oilers

Oil Type ......Model T23963 or ISO 32 Equivalent
Oil Amount ......................................... 1–2 Pumps
Lubrication Frequency ...... 4–8 Hrs. of Operation
Proper lubrication of ball oilers is done with a
pump-type oil can that has a plastic or rubberized
cone tip (see Page 36 for offerings from Grizzly).
We do not recommend using metal needle or
lance tips, as they can push the ball too far into
the oiler, break the spring seat, and lodge the ball
in the oil galley.
Figure 53. Front saddle and Y-axis handwheel
ball oilers.
Push the tip of the oil can nozzle against the ball
oiler to create a hydraulic seal, then pump the oil
can once or twice. If you see sludge and contami-
nants coming out of the lubrication area, continue
pumping the oil can until the oil runs clear. Move
the components through the entire path of travel a
few times to distribute the oil. When finished, wipe
away the excess oil.
Use Figures 52–56 to locate the 13 ball oilers on
the Model G0757.
Figure 54. Rear saddle ball oilers.
Figure 52. Ball oilers on the side of the knee
Figure 55. Horizontal spindle ball oiler.
and Z-axis crank ball oiler.
Note: The five way ball oilers shown in Figure 52
are duplicated on the other side of the machine.
Figure 56. Horizontal spindle arbor support ball
oiler.
-42-
Model G0757 (Mfg. Since 6/13)