Grizzly G0757 Owner's Manual page 12

Horizontal Spindle Control Sub-Panel
J
K
L
Figure 3. Horizontal spindle control sub-panel
located on knee.
J. Forward Button (Horizontal Spindle
Starts horizontal spindle forward rotation
(counterclockwise as viewed from the front of
the machine).
K. Horizontal Spindle Power Lamp: Illuminates
when power is enabled to the control panels.
L. STOP Button (Horizontal Spindle
horizontal spindle rotation.
M. Emergency STOP Button: Only disables
power to all horizontal spindle controls in both
panels, and stops horizontal spindle rotation.
To reset, twist the button clockwise until it
pops out.
N. Reverse Button (Horizontal Spindle
Starts horizontal spindle reverse rotation
(clockwise as viewed from the front of the
machine).
-6-
N
M
):
): Stops
):
Power Feed
A
B
Figure 4. Power feed components.
A. Limit Switch: Stops powered table move-
ment when either of the side plungers come
in contact with the limit stops.
B. Limit Stop: Limits X-axis table travel (one on
either end of the table).
C. Graduated Dial: Displays X-axis table move-
ment in 0.001" increments, with each revolu-
tion equaling 0.200" of travel.
D. Handwheel: Manually positions the table.
E. Directional Lever: Selects the direction of
table movement. The center position is neu-
tral.
F. Speed Dial: Controls the speed of table
movement. Turning the dial clockwise causes
the table to move faster.
Note: Feed rates for table travel are extreme-
ly difficult to precisely calculate. We recom-
mend that you combine research and experi-
mentation to find the feed rates that best work
for your operations.
G. Reset Button: Resets the internal circuit
breaker if the unit is overloaded and shuts
down.
H. ON/OFF Switch: Enables/disables power to
the unit.
I. Rapid Traverse Button: Once the direction-
al lever has been activated, causes the table
to travel at full speed while pushed.
Model G0757 (Mfg. Since 6/13)
D
C
E
I
F
G
H