Ricoh BRG-P1 Field Service Manual page 36

2. Installation
Menu/Menu Item Function
Dry-delay (Exit) To prevent spoiling of printed copies, select a print delivery interval to allow
them to dry.
The interval must be long enough to allow a sheet to dry. You can specify an
interval between 1 and 20 seconds.
Default: [Off]
Dry-delay (Dup) Pauses printing to allow first side of duplex print to dry before printing
second side of same page.
Note: Supported by the J028/J029/J035 only.
Paper Feed Test(*) Feeds and ejects 1 blank sheet of paper to remove moisture inside the
machine.
De-condensation(*) Feeds and ejects 3 blank sheets of paper to remove moisture inside the
machine.
System
Prt. Err Report*1 Prints error report.
Auto Continue Determines how the printer handles a print job when the specified paper size
and type is not loaded in the tray.
Off: The job does not print if the specified paper size/type is not loaded in
the tray. The job will execute once the specified paper size/type is loaded.
On: The job prints even if the specified paper size/type is not loaded in the
tray.
Sub Paper Size Determines whether to print on A4 paper if LT size paper is specified in the
printer driver, and vice versa.
Default: Off
Energy Saver Switches the energy saving function on/off. When this function is on, the
printer will automatically shut down some of its functions automatically after it
remains idle for the prescribed amount of time.
The "E. Saver Timer" can be set for 5, 15, 30, 35, 60 min.
Once the printer enters the energy save mode, it will require some time to
recover full operation once it receives a print job.
Notify by Email(*) Determines whether a notification is sent to a specified email address when a
printer error occurs. Be sure to cycle the printer off/on after doing this
setting.
34