Diagnostics Options Definitions; Disabling All Diagnostic Options For A Device - AMX NI-700 Webconsole & Programming Manual

The device will appear in the Diagnostics Options window, in the next available column (to the right of the last device added
- see FIG. 54).
Edit Options window indicating four devices with Diagnostics enabled
FIG. 54
NOTE: You can monitor diagnostics for up to eight System Devices in this page.
Diagnostics Options Def initions
The following table describes each of diagnostics options that can be enabled via the Edit Options window:
Diagnostic Options
Diagnostic Option
All Notifications:
System
• Number
• Device
• Port:
Messages
• Online/Offline
• Configuration
• Status
Channel Changes
• Input
• Output
• Feedback
Device Options
• Level Changes From
• Level Changes To
• Strings To
• Strings From
• Commands To
• Commands From
• Custom Events From

Disabling all Diagnostic Options For a Device

There are two ways to disable all diagnostics for a device:
In the Edit Options window, select Delete to remove the device from the Diagnostics Options page and disable all

diagnostics.
In the Edit Options window, deselect all selected diagnostics options and click Update. This disables all diagnostics for this

device, but leaves the device on the Diagnostics Options page.
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
Description
Enables every notification field.
Use these fields to enter a Device:Port:System (D:P:S) combination for the device for which you want to enable
notifications. A value of 0 for any option gives you all of the systems, devices, or ports. This dialog also allows
you to store/recall presets.
Generates a message when there is a change in the target device's online/offline status.
Generates a message when there is a change in the target device's configuration.
Generates a message when there is a change in the target device's status.
Generates a message when there is an input channel change (i.e. Push/Release) in the target device.
Generates a message when there is an output channel change (i.e. CHON/CHOFF) in the target device.
Generates a message when there is a feedback channel change in the target device.
Generates a message when there is a level channel change from the target device.
Generates a message when there is a level channel change to the target device.
Generates a message when there is a string sent to the target device.
Generates a message when there is a string from the target device.
Generates a message when there is a command to the target device.
Generates a message when there is a command from the target device.
Generates a message there is a custom event occurring from the target device.
WebConsole - System Options
50