AMX NI-700 Webconsole & Programming Manual page 46

Select Control/Emulate from within a selected Device's Network Settings page
FIG. 49
2. Select either the Control or Emulate option.
3. In the Channel Code section, enter a valid Channel number to emulate Channel messages (i.e., Push/Release, CHON, and
CHOFF) for the specified <D:P:S>.
The Channel number range is 1 - 65535.

Select the On or Off buttons to Emulate Channel ON (CHON) and Channel OFF (CHOFF) messages for the specified <D:P:S>.

4. Select the Push button to Emulate a push/release on the specified channel (not displayed if the Control option is selected).
Click and hold the Push button to observe how the device/Master responds to the push message.
5. In the Level Code section, enter a valid Level number and Level data value for the specified <D:P:S> and press the Send button
to transmit the level data.
The Level number range is 1 - 65535.

The table below lists the valid Level data types and their ranges:

6. In the Command and String fields, enter any character strings that can be sent as either a String or Command, and press Send
to transmit to the Master.
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
Click on Control/Emulate from within
the device's Network Settings page
to Control/Emulate that device
Level Data Type Minimum Value
CHAR 0
INTEGER 0
SINTEGER -32768
LONG 0
SLONG -2147483648
FLOAT -3.402823466e+38 3.402823466e+38
Maximum Value
255
65535
32767
429497295
2147483647
WebConsole - System Options
46