Strip Issue Back Feed Setting (Peel Bf.) * Supported On V1.0E Or Later - Toshiba B-EP Series Key Operation Specification

6.6.2.2.8 Strip Issue Back Feed Setting (PEEL BF.) * Supported on V1.0E or later.

When strip position fine adjustment is set to – (negative) by using a command or in system mode,
the strip position is finely adjusted and the printing is misaligned simultaneously. This setting is
used to perform a back feed and thus correct the print position for the purpose of printing on the
normal position.
P E E L B F .
P E E L B F .
Default value: OFF (No back feed performed)
<Commentary>
When the gap length is 5 mm or more, printing is not misaligned on the label, although the strip
position fine adjustment is set to - (negative). Therefore, no back feed is performed when ON
(back feed performed) is selected in this setting.
<Supplemental Explanations>
When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter
setting, repeat mode is enabled and the key pressed is repeatedly entered.
The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
O F F
[PAUSE]
O N
[PAUSE]
- 78 -
Performs no back feed.
Performs a back feed.