Back Feed Restriction Setting (Bf.restrict) * Supported On V1.0E Or Later - Toshiba B-EP Series Key Operation Specification

6.6.2.2.7 Back Feed Restriction Setting (BF.RESTRICT) * Supported on V1.0E or later.

B F . R E S T R I C T
B F . R E S T R I C T
Default value: ON (Back feed restricted)
<Commentary>
During label issue with sensor type specified (transmissive/reflective sensor) under the following
conditions, this setting determines whether or not to perform a back feed.
However, when linerless setting is enabled, the following conditions are ignored and whether or not
to perform a back feed is determined according to this setting.
The label pitch is 20.0 mm or more and less than 24.0 mm and the effective print length is less
than 15.0 mm.
The label pitch is less than 20.0 mm.
During label issue without sensor type specified, whether or not to perform a back feed is
determined according this setting.
When a feed is performed by using the [FEED] key or the Feed command, no back feed is
performed. However, when the label pitch is less than a distance between the head and the
sensor (11.5 mm), a back feed is performed regardless of this setting.
<Supplemental Explanations>
When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter
setting, repeat mode is enabled and the key pressed is repeatedly entered.
The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
When back feed restriction is disabled (to perform a back feed), the paper stops at the cut position
regardless of the post-print stop position setting (stop at the cut position/stop at the head position)
in section 6.6.2.2.6.
When linerless setting is changed from OFF (disabled) to ON (enabled), back feed restriction is
automatically turned OFF (back feed not restricted).
When linerless setting is changed from ON (enabled) to OFF (disabled), back feed restriction is
automatically turned ON (back feed restricted).
O N
[PAUSE]
O F F
[PAUSE]
- 77 -
Back feed restricted
(Performs no back feed.)
Back feed not restricted
(Performs a back feed.)