System Limits; Determining The Outline Quantities Of The Software - Siemens FS20 Planning Manual

System limits

10

Determining the outline quantities of the software

10 System limits
10.1 Determining the outline quantities of the software
Parameters
'Areas'
'Sections'
'Zones' per 'Station'
'Zones' per 'Area'
Fire incident control groups
EVAC control groups
2
Controls per ↑ control
group
2
Total of all ↑ control groups
and controls per 'Station'
Causes per control
↑ Effects per control
Effects per 'Station'
3
Entries in event memory
140 | 242
Building Technologies
Fire Safety
The number of logic units and controls is limited for each fire control panel. The
following limit values apply for the different fire control panels:
General restriction
A maximum of 1000 'Zones' are permitted for each 'Area'.
FC2020 FC2030
4 4
50 200
252 756
1000 1000
50 150
2
50 150
100 100
100 200
2
50 50
50 50
700 1400
2000 2000
5
Table 39: Maximum number of logic units/controls for each fire control panel
The FC2030 fire control panel is based on the FC2020 and can also hold a
1
maximum of 2 line cards for ↑ detector line migration.
Controls are grouped in control groups, for simplified configuration and operation
2
in the system. Control groups need system resources; the number of control
groups (e.g., fire control groups and EVAC control groups) must therefore be taken
into account when determining the ↑ outline quantities.
The effect must be on the same ↑ station as the configured control.
3
Fire control panels FC2060 with the PMI & mainboard FCM2004 are not
4
supported by market package MPEN 4.0 because of memory restrictions.
May be higher for specific countries (number of events, standard 2000 + number
5
of guaranteed alarms + number of guaranteed isolations).
FC2040
4
100
504
1
1000
100
100
100
200
50
50
1400
2000
FC2060 FC2080
4
8 24
200 400
1512 3000
1000 1000
150 250
150 250
100 100
350 500
50 50
50 50
2100 3000
2000 2000
008843_v_en_--
2015-12-15