10 Customer- -Specific Operator Interface
10.5
OP hotkeys, PLC keys
10.5
OP hotkeys, PLC keys
OP hotkeys
PLC keys
Configuration
10-158
You can configure the keys "Position", "Program", "Offset", "Program Manager",
"Alarm" and "Custom" on the operator panel to branch to an operating area of
your choice.
You can configure so--called "PLC keys" to branch to particular operating areas.
You can switch to the following operating areas with the OP hotkeys or PLC
keys:
ShopMill on NCU (HMI Embedded)
S
From ShopMill to any operating area of ShopMill .
PCU 50.3
S
From ShopMill to any other operating area in ShopMill.
From ShopMill to any other operating area in HMI Advanced and vice versa.
You can find information on configuration in:
References:
/IAM/, Commissioning Manual CNC: Basic software and
HMI Advanced, SINUMERIK 840D sl/840D/840Di/810D,
/IHE/, Commissioning Manual CNC: Basic software and
HMI Embedded, SINUMERIK 840D sl,
keyword "OP hotkeys" and "PLC keys"
Note
The configuration of the "PLC Keys" in ShopMill is carried out in the file
KEYS.INI, not via DB 19 interface.
The file KEYS.INI must feature the following entry in the section
[HMI_INI_FILES]:
Task6 = shopmill.ini
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill - - 11/2006 Edition
BE1 Operator interface extension
BE1 Operator interface extension
© Siemens AG 2006 All Rights Reserved
11/2006
J