Siemens SINUMERIK 840DE sl Commissioning Manual page 55

11/2006
9658
MD number
Default setting: 0.01
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9659
MD number
Default setting: –1
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9660
MD number
Default setting: 1
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9662
MD number
Default setting: 1
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9663
MD number
Default setting: 1
Change becomes effective after: POWER ON
Data type: BYTE
Significance:
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
$MM_CMM_CYC_MAX_CONT_PO_T O_RAD
Variation of largest possible cutter radius
Min. input limit: 0.0
Protection level: 3/4
This MD is required for milling contour pockets. This parameter is used to stipulate the
amount by which the radius of the cutter being used may be larger than the one used for
generation.
$MM_CMM_CYC_DRILL_RELEASE_ANGLE
Tool orientation angle on retraction
Min. input limit: –1
Protection level: 3/4
This MD is used to determine the spindle position (0...360
nal turning tool, remains in a boring.
Note:
–1 means that the value for the tool orientation angle can be entered on the operator inter-
face.
$MM_CMM_ENABLE_PLANE_CHANGE
Changing to machining plane (G17, G18, G19)
Min. input limit: 0
Protection level: 3/4
Enable change to machining plane (G17, G18, G19):
0 = Changing to machining plane (G17, G18, G19) not possible
1 =
Changing to machining plane (G17, G18, G19) possible
$MM_CMM_COUNT_GEAR_STEPS
Number of gear stages
Min. input limit: 0
Protection level: 3/4
This MD is for setting the number of gear steps (0 to 5) for the spindle. The possibility of
input in the operator interface is thus restricted.
$MM_CMM_TOOL_DISPLAY_IN_DIAM
Display radius/diameter for tool
Min. input limit: 0
Protection level: 3/4
This MD is used to define how the tool should be displayed or entered:
0 = radius
1 = diameter
7.2 Display machine data for ShopMill
Max. input limit: 10.0
Units: mm
Valid as of software version
ShopMill 4.3
Max. input limit: 360
Units: Degr.
Valid as of software version
ShopMill 4.3
0
) at which the tool, e.g. an inter-
Max. input limit: 1
Units: –
Valid as of software version
ShopMill 4.3
Max. input limit: 5
Units: –
Valid as of software version
ShopMill 4.3
Max. input limit: 1
Units: –
Valid as of software version
ShopMill 4.3
7 Machine Data
7-55