Designating A Load Magazine In The Tool List Sorted According To Magazines - Siemens SINUMERIK 840DE sl Commissioning Manual

8 Tool Management
8.10 Configuring the operator interface
8.10.6 Designating a load magazine in the tool list sorted according to
magazines
Example
8-118
If the tool list is sorted according to magazines, all of the magazine locations are
displayed in an increasing sequence according to magazine location and maga-
zine number. Using the configuration time to_mill.ini, a magazine can be high-
lighted as load magazine by sorting this magazine so that it is directly located
after the magazine locations of the buffer.
ID for the load magazine:
OEM_LOAD_MAGAZINE
[OEM_LOAD_MAGAZINE]
MAGAZINE = 3
In this example, magazine 3 is configured as load magazine,. The magazine
locations of magazine 3 are displayed directly after the magazine locations of
the buffer in the tool list sorted according to magazine locations.
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
© Siemens AG 2006 All Rights Reserved
11/2006