Siemens SINUMERIK 840DE sl Commissioning Manual page 61

11/2006
9718
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
9719
MD number
Default setting: H5
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
9720
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
$MM_CMM_OPTION_MASK_2
Settings for ShopMill
Min. input limit: 0000
Protection level: 1
Bit 0: Do not jump to Automatic mode when an external program (from the PLC) is selected
for execution.
Bit 1: Influence the simulation speed through feed rate override.
Bit 2: Do not display the basic offset in the measuring and program mask and cannot be
entered.
Bit 3 to bit 6: Reserved
Bit7: Deactivate the function approaching and departing along the software limit switches
for the swivel heads.
Bit 8: Reserved
Bit 9 to 12: Reserved
Bit 13: The correction angle is inverted during boring (E_DE_BOR).
$MM_CMM_OPTION_MASK
Settings for ShopMill
Min. input limit: 0000
Protection level: 1
Bits 0 to 8: Reserved
Bit 9: Start program execution in all screens.
Bit 10 to 11: Reserved
Bit 12: Display of all axes (up to 14 axes)
Bit 13 to bit 17: Reserved
Bit 18: When changing Manual/MDA/Auto, change the mode but not the ShopMill interface.
Bit 19: Instead of "MCS" and "WCS" display texts "Machine" and "Workpiece".
Bit 20: Display work offsets not as "ZO1", but as "G54" (except in the work offset list).
Bit 21: Enable basic record display.
Bit 22 to bit 25: Reserved
Bit 26: Enable directory "Part programs" in program manager.
Bit 27: Enable directory "Subroutines" in program manager.
Bit 28 to bit 30: Reserved
Bit 31: Always display coordinates system for G17 as follows: X to right, Y up (right–
handed coordinates system) or down (left–handed coordinates system).
$MM_CMM_ENABLE_B_AXIS
Enable 5th axis for operator interface
Min. input limit: 0
Protection level: 3/4
5. Enable 5th axis (e.g. B axis) for operator interface:
0 = 5th axis is not displayed on the operator interface
1 = 5th axis is displayed on the operator interface
2 = 5th axis is displayed on the operator interface and can be programmed
3 = 5th axis is displayed on the operator interface only for reference point approach
7.2 Display machine data for ShopMill
Max. input limit: FFFF
Units: Hex
Valid as of software version
ShopMill 7.1
Max. input limit: FFFF
Units: Hex
Valid as of software version
ShopMill 6.4
Max. input limit: 3
Units: –
Valid as of software version
ShopMill 5.1
7 Machine Data
7-61