Diagnostic; Commands; Current Flow Rate (Fr); Peak Flow Rate (Pf) - Pentair FLECK 9000 SXT Installer Manual

Installer Manual Fleck 9000 - SXT - Programming
6.6.

Diagnostic

Note
If none of the buttons are pushed for 1 minute in the diagnostic mode the controller returns
to Service mode.

6.6.1. Commands

A Press and hold
B Press or
C Press to exit the Diagnostic mode at any time.

6.6.2. Current flow rate (FR)

Note
The display is updated every second.
A Current flow rate display (L/min or gpm depending on display format
programmed):

6.6.3. Peak flow rate (PF)

Note
The controller registers the highest flow rate (L/min) since the last regeneration.
B Peak flow rate display:

6.6.4. Hours since last regeneration (HR)

Note
Shows the number of hours since the last regeneration, indicating the length of the current
service cycle.
C Hours since last regeneration display:
58 / 108
and for five seconds to enter the diagnostic mode.
to navigate in the diagnostic mode.
Ref. MKT-IM-020 / B - 08.06.2018