Cisco TelePresence Server 7010 Product User Manual page 17

Field Field description
IP Select Disabled, Automatic via
configuration SLAAC/DHCPv6 or Manual.
If you select Manual, you must also supply
the IPv6 address, prefix length and default
gateway.
If you select Automatic via SLAAC/DHCPv6,
the TelePresence Server automatically gets
an IPv6 address. It uses SLAAC, Stateful
DHCPv6 or Stateless DHCPv6 as indicated
by the ICMPv6 Router Advertisement (RA)
messages (see Automatic IPv6 address
preferences below).
IP address If you chose Manual configuration, supply
the IPv6 address in CIDR format. Enclose
the address in square brackets, for example
[fe80::202:b3ff:fe1e:8329], in the
user interface.
Prefix length If you chose Manual configuration, supply
the prefix length.
Default (Optional) Supply the IPv6 address of the
gateway default gateway on this subnet.
IP status
The IP status section shows the current IP settings for this Ethernet port of the TelePresence Server, as
follows, whether they were automatically or manually configured.
IPv4 settings:
DHCP
n
IP address
n
Subnet mask
n
Default gateway
n
IPv6 settings:
DHCPv6
n
IPv6 address
n
IPv6 default gateway
n
IPv6 link-local address
n
Ethernet configuration
Configure the Ethernet settings for this port of the TelePresence Server, and then click Update Ethernet
configuration.
Cisco TelePresence Server Product User Guide
IPv6 configuration
Usage tips
Disable IPv6 on the port if the network does
not support IPv6.
You only need to enter an address if you
chose Manual IP configuration. If you chose
Automatic via SLAAC/DHCPv6, a manually
entered setting is ignored.
The prefix length is the (decimal) number of
bits that are fixed for this address.
The address may be global or link-local
Network settings
Page 17 of 151